I-Data Electronic Documentation ida Manuel d'utilisateur télécharger pdf (Page 24)

Specifying Share Timeout and String

ida FS 250, Operator's Guide

-24-

5. Specifying Share Timeout and String

In order to specify the timeout for a specific input port, an FSL ( Function

Selection via the Line) sequence must be sent to the port in question. To do

this a temporary Escape (ESC) Character must be defined first. This is done

in the following way:

&&??<character>

The sequence "&&??%" will define " %" as the ESC Character.

Timeout is specified in FSL Function 100 . This function has the following

syntax ("%" is the ESC Character):

%Y100,<timeout>[,user string]%

Factory default = 20 seconds

Timeout: 1 to 255 indicating number of seconds

User string: Optional - string in HEX to be sent to the

printer before transmission of data, when the

printer is selected by the share unit.

If function 100 is sent to the twinax, a user

string number can be defined instead of a

HEX string. The user string then has to be

defined in function 61.

NOTE:

The Timeout string must be written in ONE line (see example below).

The user string and settings will only be sent if a share condition has

occurred.

The new setup must be saved in the NVRAM with the following command

("%" is the ESC Character):

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Pas de commentaire

I-Data Electronic Documentation ida Manuel d'utilisateur Page 24