I-Data Electronic Documentation ida Manuel d'utilisateur télécharger pdf (Page 12)

Connecting to System

ida FS 250, Operator's Guide

-12-

3. Installation and Connections of the

ida FS 250

This chapter starts with an overview of the functionality of the rear panel.

Then follows a description of how you connect the ida FS 250 box to a

printer and finally you will find instructions for connection to a system.

NOTE:

Before you start the installation, make sure that you set the address

switch and the desired emulation. See the description in the section:

Emulation.

3.1 The Rear Panel

RS232

12-18 VDC.

0.7A

PARALLEL IN PARALLEL OUTADDR

+ --

A = PCL

Fig 2-1 ida FS 250 Rear Panel

PARALLEL OUT

The parallel output port is connected to the parallel/Centronics in put port

on the target printer (standard parallel out cable supplied with printer

should be used).

PARALLEL IN

The parallel input port can be connected to the parallel/Centronics out put

on a PC or similar source which enables it to share the printer with the

host. For this connection you need a spare part cable ending in a 25-pole

D-Sub connector (i-data order no. 999022 030).

SERIAL (IN/OUT) RS232

The serial port can be configured either as input or as output.

Default configuration is input.

Serial input

The serial port is connected to the serial output on a PC or similar source able

to share the printer with the host.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Pas de commentaire

I-Data Electronic Documentation ida Manuel d'utilisateur Page 12