I-data POLARIS Panel PC 19.1" Manuel d'utilisateur télécharger pdf (Page 24)

User manual

POLARIS Panel PC 19.1'' and Panel PC 15''

Version 2.00 Page 24 of 46

E_BMS790_POLARIS_PanelPC_19+15_Rev1.doc • User manual for POLARIS Panel PC 19.1" and 15" • Revision 1 / Status: January, 3

, 2006 • Technical data subject to change

5.4 Mechanical installation

In order to achieve an even clamping pressure, it is recommended that the reinforcement frame (not included in the scope

of the delivery) be inserted between the mounting clamps (included in scope of the delivery) and the enclosure.

■ Tighten the fixing screws in the mounting brackets slightly.

■ Check the position of the display and the seal.

■ Tighten the set screws so as to ensure an adequate seal on the POLARIS

Panel PC is assured.

5.4.1 Recommended enclosure

■ Stainless steel enclosure with wall thickness > 2 mm. In this case the

reinforcement frame between the retaining clips and enclosure material should always

be used.

■ Reinforcement frame for maintenance of Protection Class IP 65

for POLARIS Panel PC 19.1" (05-0205-0010)

for POLARIS Panel PC 15" (05-0205-0009)

5.4.2 Special installation instructions

In order to guarantee the IP degree of enclosure protection = IP 54 for installation in 2G enclosures of Ex e type

of protection (e.g. control equipment), and = IP 6X for installation in 2D enclosures in areas where combustible

dusts exist - with “protection through the enclosure” type of protection - the reinforcement frame should be used

for fastening on the front side.

5.4.3 Cover Ex i terminal box

When using a housing with a degree of protection of at least IP 20, the cover for the Ex i box can be dispensed

with.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Pas de commentaire

I-data POLARIS Panel PC 19.1" Manuel d'utilisateur Page 24